750turbo.com

Hi, I have a model for this part, but cannot get a satisfactory finish due to the nature of 3D printing.

Adrian

Z-Power now do a fibreglass version UK long & US Short version.

Adrian

I got replacement ) seal for sub oil pan from simplybearings.co.uk, BS159 2.62mm Section 126.67mm Bore NITRILE 70 Rubber O-Rings
No more leaks after fitting this one.

Regards
Adrian

Hi Rockbridge,
Unfortuneatley I cannot make this item as I have no CAD model to print from & is too large, even in halves, to print on my large machine.
Sorry.

Regards
Adrian.

Hi, You have spelt my email incorrectly that is why I didn't receive it.
I'll have a look at my stock & get back to you.

Adrian

PLEASE DO NOT USE THIS THREAD FOR 3D PRINTED PARTS, PLEASE GOTO '3D PRINTED REPLICA ITEMS' THREAD INSTEAD AS THIS CONTAINS PRICING & OEM PART NUMBERS.

Betterthanfabio wrote:Ok anyone know if these the same as the "Australian" model with the sight glass on the other side (front) of the master cyl?

Hi, I have just compared it to my UK model & looks the same size. The original was modelled on the US version & appears to be the same..

Adrian

Just added replacement master cylinder lens. This is made from Alloy 910 (Nylon, It has been approved by the manuafcturer for use with DOT 4 brake fluid only) & has been tested by another member of this forum successfully. The condition of the OEM seal is important that it does not have any major ...

TurboRestorer wrote:

JezZedexE1 wrote:

hard part is getting the buggers on !!

Maybe have them made/printed as a 2 part assembly.

I will change print settings but for now hot water works.

Adrian

I now have a softer rubber to play with & test.

Any luck with the surge tank covers?[/quote]
Hi, Here is an update on the surge tank covers as far as I have got. The bottom mounts need to be modelled & will be a weak point that I will try & strengthen as these are plastic & not pressed steel.
Here are some initial models for left & right that I ...

JezZedexE1 wrote:

hard part is getting the buggers on !!

Maybe have them made/printed as a 2 part assembly.

I will change print settings but for now hot water works.

Adrian

Hey Adrian I need to order more dampers for the waste gates if you have any available??? let me know.

Thanks man

Charlie
Hi Charlie, I wasn't sure how well they were doing in the field.
I can print however many you require, I still have a few from the last batch available. Let me know numbers ...

Any luck with the surge tank covers?
Hi, I have been busy with other projects including designing planetary gearboxes for better prints & haven't forgotten about these covers but thay have taken a back seat for the moment. When I do copy one of my OEM covers I will need an external tester to try ...

Whenever I have my turbo the road, I get insurance through carole nash & they send me forms to fill out to send to VJMC for agreed valuation. I end up sending pics taken over long period of time, mag. articles its been featured in, any receipts or other documentation to justfy the value.

I would take the plug out & rotate to align TDC @ no1 then look through plug hole to see if any valves are open with a torch, its a little awkward to do thou.