3D Printed Replica Items

[JezZedexE1]

Oh crap. Something is wrong.

I will replace it as soon as I find out where I cocked up.

[TurboRestorer]

I looked online & the drawing you gave me looks correct, I just don't know why mine has 9mm holes instead of 4.4mm holes. I was hoping someone could look at their bike & confirm 9mm or 4.4mm.

[JezZedexE1]

Here is a revision.

revised 92075-078.pdf

(25.43 KiB) Downloaded 368 times

[145turbo]

Just checked, mine has 9mm hole

[145turbo]

Had another look at pic that Jez sent...it points to 8.8mm which probably allows for fitting into the 9mm hole. .... i think

[TurboRestorer]

Had another look at pic that Jez sent...it points to 8.8mm which probably allows for fitting into the 9mm hole. .... i think

Thats the new revised file which I have just adjusted the CAD drawing to. Ready to print now.

[TurboRestorer]

Hi, Dampers for the battery cover/tank mount brace are now available as listed.

Regards,
Adrian

[TurboStew]

Good job Adrian on these parts, Stewart

[Witchita Linemen]

Hi Adrian,
Have you done up 92075-1312. This is the rectangular rubber hanger that holds the ECU in place. There's also a couple of them on the backside of the plenum holding the boost sensor in place. I would be happy to buy some if you have them. I didn't see it on your list.

[georgew4714]

Adrian may be able to supply them cheaper and i have a few of his other quality repros but as a backup , Partzilla has them in stock for $7.58 ea.

[TurboRestorer]

Hi Guys,
Those little ECU/relay dampers are an easy thing to make so I'll have something before the end of this week for you. Currently both printers are in use for classic Mini parts & I've designed my own larger printer 400x400x400 which could be used for larger items on the bike (if it works!)
Looking at your Partzilla price/each I could probably do a complete set for that + P&P, but I'll do the model & test prints first.

Regards,
Adrian

[Witchita Linemen]

Cool! Eagerly standing by. I'd much rather spend my pennies here than at Partsazilla!

[TurboRestorer]

These will be a tighter fit than OEM ones, I found the OEM ones were a little on the soft side allowing the relay to 'flop' about after some time. these should 'click' into place & are a better material.
Currently printing 2 sets of 5, 3x ECU + 2x Dual relay.

Adrian

[georgew4714]

You da man Adrian

[Witchita Linemen]

WhooHoo!